M. No.: 3284 Equipment / Additional information: (min.) material thickness: 0.65 mm (max.) material thickness: 2 mm Technical Data: Width of film, max./min. 450/350 mm Forming area max. 430 x 160 mm Drawing depth max. negative/positive 6/20 mm (on request 22 mm negative) Top heater max. 10,15 kW Driving motors 3,0 kW Total connected load at 100 % duty cycle 12,7 kW Working air pressure 6 bar Air consumption (dependent on product) max. 1250 I/min Rate of water flow max. 1,0 m3/h COMPACT AND ROBUST - giving continuous high output. Easy and ergonomical operation (e.g. take- off height 1300 mm). QUICKLY CHANGEOVER - from 30° to 90° foil feed giving maximum material utilisation for both square and round lids. Heater changeover problem-free. PRECISION - The accuracy of the form table movement is guaranteed by linear guide bearings and hardened rods. The safe ...
Used Gabler M90 Thermoformer, age 1993, reportedly only used for approximate 30,000 hrs., Material Roll stand, Gabler, 2 x Roll Preheater; also acts as unwinder., Double heating, Top & Bottom Heaters total rating 86.1 kW, Total motor rating 15 kW, Pneumatic Plug Assist, Max Forming Area 700 x 300 mm, Max Film Width 730 mm, Max Depth of Draw 150 mm, Lower Form Platen swivels through a max. of 90 degs using a heavy duty Servo-driven Planetary Drive, Stacking / counting Station, Delivers counted products at 90 degs to machine direction, Skeletal waste material turned through 90 degs., Herbold Grinder, Suitable for PS, OPS, PVC, PP, ABS, Siemens S5 PLC, 400V 3phase, 50 Hz, Preheater: Gabler, 2-Roll, max. Form Area: 700 x 300 mm, max. Film width: 730 mm, max. Draw depth: 150 mm, Form Station: Heavy duty with Lower tilting Platten, Grinder: Herbold
Forming surface: 750x436mm, heating output: 155kW, max. compressed air supply: 10bar, weight: 9.2t, operational hours counter: 43,589h.
Age 2000, Lower Form Table upgraded recently by Gabler to be able to run PET products, original closing force was 75kN, upgraded to 115kN. i.e. the Thermoformer can now work with PET, PP, PS, HIPS etc., Hours run only 37,500 hrs!, Preheater ILLIG VHW 72, 2-Roll Preheater for PP, Gabler SWING Thermoformer:, Max. sheet width 480 mm, Double Heating Oven, Max. Form Area 450 x 220 mm, Max. depth of draw 125 mm, Stacker / Counter, Delivery conveyor for Counted Products, Inline Skeletal Waste Material Winder, Max. Dry Cycle speed 44 cycles/ min., Machine is well maintained and in v. good production condition, Inclusive of:, 1 Bosch Sprang 6 cavity Ø75 PP cup tool, age 2000 with Stacker Parts, The mold is very sparingly used and in great condition., Film width: 480 mm, Form Area: 450 x 220 mm, draw: 125 mm
