Used Chain Conveyor Belt
Manufacturer: PAAL
Type: KEM 1500
Year of construction: 2008
specifications:
Conveyor width: approx. 1,500 mm
Wheelbase:approx. 9,625 mm
Strip course: approx. 2,935 mm horizontally underfloor,
then rising to a length of approx. 4,500 mm below 28°,
sloping below 10° on the remaining length and conveying into the
press
Conveyor belt speed: 0.27 m/sec
Conveyor belt drive power: 4.0 kW
Sidewall heights
- in the horizontal part: 527 mm
- in the climbing section: 777 mm
Operating voltage: 3 x 400 VAC / 50 Hz / N / PE
as far as possible pre-assembled, consisting of:
- Strip scaffolding in solidly welded section steel and sheet steel
edge construction,
- additional sliding guides underneath the belt support profiles in
the horizontal and climbing sections to support heavy loads,
- Conveyor belt (quality: EP 200/2 2:1) with 20 mm high T-studs on the
sides for belt string sealing,
- Belt routing in a neutral zone to avoid strain stresses,
- Chain type M-80 with case-hardened bushings, bolts and rollers,
- Chain plates with reinforced support brackets and partly with
replaceable, lateral plastic chain protectors,
- Chain strand breaking load 8 t, (16 t static load with a nominal
width of 1.2 m to approx. 700 kg per m belt length),
- Belt support profiles at a distance of 250 mm torsionally rigid with
4 screws each B51239235 attached to the chain plates without belt
intermediate layer,
- Driver above the belt at a distance of 500 mm, consisting of 40 mm
high angle steel,
- Bevel gear drive motor with integrated brake,
- drip oiler for uniform lubrication of the chains,
- Conveyor belt supports made of section steel construction with
height adjustment,
- Emergency stop switch on the side of the conveyor belt and cable
pull emergency stop above the conveyor belt in standard design,
- Start/stop switch on both sides of the rising conveyor belt
frame,
- Synthetic resin top coat in light blue according to RAL 5012
Germany
49324 Melle 
