Seller: MATEC system+technik GmbH
Wood drying chamber Bollmann L x W x H outside: 11.0 x 3,0 x 2,7 m Stack dimensions B x H: 1.5 x 2.0 m Weight approx. 2000 kg Built in 1982 The wood drying chamber is in good condition, ready to use. Subject to changes, errors, prior sale! Service/spare parts by MATEC CH-4900 Langenthal/DE-79618 Rheinfelden MATEC system + technik GmbH Mechanical engineering Eisenbahnstrasse 25 CH-4900 Langenthal/Switzerland Tel. 0041 62 966 18 32 Fax 0041 62 966 21 12
Seller: DH Maschinenhandel
Vacuum dryer model KVT 200, WW heated, length 6m, diameter 1400, little run with slide-in trolley, year of construction 1989
Drying kiln of capacity of cu.m 80 INTERNAL DIMENSIONS 9000 x 7000 x h net 4100 mm nr. 6 Fans INVERTER for ventilation control Nominal range of each fan 30.000 m3/h Water heating fluid 90° C – At12 Humidification system by Nozzles at high nebulizing power Expelling Chimneys Control at 6 wood Probes Deflectors for air canalization
The pass-through dryer is operational, the fans have been replaced with energy-saving ones.
Seller: MEDIENOS STAKLES, UAB
20-15- Timber drying kiln (new) Type CSD-HT-BR 70 Internal dimensions (width x depth x height) 7500 x 7160 x 4100 mm External dimensions (width x depth x height) 8080 x 7760 x 5500 mm The section of the structural columns of the chamber is 160 x 70 mm Snow load for the roof is 80 Kg/m2 Wind resistance of walls 27.8 m/sec Warming with glass wool Walls ǂ100mm Roof ǂ100mm Door ǂ100mm Door: sliding type, hung on a rail Wood for drying: various Loading the drying chamber with a forklift The heating system is gas Fuel - GPL gas Maximum thermal energy (300 kW) Maximum chamber temperature 75 °C The number of fans in the chamber is 5x3kw The total capacity of the fans is 162,500 m3/hour Number of probes: 4 HT/ 8 AWM/ 2 EMC/ 2 Temperature Voltage 400 V 50 Hz Total power 17kw)
Seller: WISSMATEC
Drying container WISSMATEC Continuous dryer Drying system Year of construction 2024 Drying floor with slotted bridge sheets Hydraulic moving floor Outlet opening at the rear Filling and exhaust air opening at the top Drying capacity is dependent of material Material Material moisture
