Pellet mill / press CPM 7900 aftre renovation Dia inch : 30 - 762 mm Die width : 8 - 210 mm Die surface 5025 cm² KW : 250 KW Machine type : 7900 Buildyear : 1984 Width rollers : 215 mm Dia rollers : 350 mm 1 set rollers Oil cooling Twin mixer 2 x 15 KW / Die Hosting system New inlet in stainless steel
Complete pellet line for biomass or animal feed. CPM 3020-4 with 132 kW motor Including CPM Conditioner, CPM press and Geeelen cooler with fan and cyclone. Positive direct gear drive 132 kW, provides a 98% energy transfer Rounded cast gear case with internal ribbing for quieter operation Segmented die clamps for quicker die changes Metal-to-metal seals between components Modular gearbox design for production flexibility Replaceable quill flange Stainless steel pellet chamber Single motor 132 kW for greater efficiency Very good condition.
Assembled Knife Holder for CPM 7930 Model 30-4 Knives included
2 pcs clamping jaws 22" / Die Clamp Segment Assy 22" for pellet mills CPM 7722-2 and CPM 3022-2 Plus Transportation
For sale complete plant for wood pellet production, made from CPM, capacity 6t/h. A most of the maschines from line are produced in between 2008-2010.y., except presses for making pellets (its bit older then rest of the line, but completly renewed before restarting. Line is consisting from: 1.Chain conveyer for logs transport. 2.Lift with angle platform for dosing material. 3.Entrance belt transporter with magnetic section for detection of iron. 4.Grinder (hammer mill) BRUKS 500kW 5.Verticaly basket transporter for chip wood. 6.Horisontal belt transporter for chip wood with three side ejectors into depoos (separated with type of the wood) 7.Hidraulic floor platform for dosing wood chips (three pcs.) with all instalation and system of hidraulic pistons. 8.Horisontal belt transporter for transportation material on drying. 9.Repler transporter for driving wood chips into fire plac ...
Collier sleeve Fishbone CPM 22-2.5 for pellet press
Collier sleeves Fishbone CPM 16-2.5
Freshly Revised Koller to CPM Press 3022 or 7022 , Fshbone, 2 new bearings, new sleeve, new intermediate ring, filled with grease. rest used. Koller are no longer needed due to machine changes. 3 pieces Available
Freshly revised Koller to CPM Press 3022 or 7022 Punched, 2 new bearings, new sleeve, new intermediate ring, filled with grease. rest used. Koller are no longer needed due to machine changes. 3 pieces Available
