turning diameter over bed: 400 mm
turning diameter over slide
rest: 210 mm
turning length: 1060 mm
centre height: 200
mm
spindle bore: 58 mm
spindle taper: Camlock: D 1-6
Drive: 3,2/4,9 kW
spindle turning speed range: 16, von 55 bis
1600 U/min
feeds - longitudinal: 0,039-0,541 mm/U
feeds cross:
0,019-0,271 mm/min.
weight of the machine ca.: 1,45
t
dimensions of the machine ca.: 1900 x 870 x 1700
mm
Condition: ready for operation:
Condition: good:
Electric 380 Volt:
3-axis digital readout: Fagor VN 300 T
3 jaw chuck: Röhm F 200 mm
Multifix-steel holder: Typ B
Foot brake:
Cooling equipment:
Rear chip protect:
chip pan:
Machinelight:
Center:
Faceplate:
Röhm 300 mm
Boring chuck:
High-quality machine with
induction-hardened guideways, torsionally rigid bed,
main spindle
made of chrome-nickel steel, surface-hardened and ground gears,
automatic circulating lubrication in the spindle housing, slip
clutch in the
support, bed lubrication via hand pump, Siemens
electrical system. Thread feeds
for metric, inch, module, and
diametral P51219061 pitch.
3-axis digital readout: 2 scales are
mounted, the scale on the top slide
has been replaced but still
needs to be mounted. The display unit is for
lathes and therefore,
with the appropriate setting, adds the slide travel to
the top
slide travel.
The machine was only used in a prototype workshop
for sporadic applications.
Machine dealer with own stock of 1600
m².
The data for this ad was created
with ModulMWS - the software solution of LogoTech oHG.
