STIGAL DYNAMIC plasma-gas cutting machine was built in 2014 in Poland
by STIGAL Marcin Stępień. The machine is used for the precision
cutting of sheet metal with a maximum thickness of 60 mm. The cutting
process is performed automatically on a work table with dimensions of
3000 x 2000 mm. The CEBORA PLASMA PROF source generates a stable
plasma arc, which ensures effective cutting of the material and
maintains optimal operating parameters even during intensive use.
A spark shield is installed next to the plasma torch to protect the
eyes of the operator and anyone else in the vicinity of the operating
machine. Thanks to this, the operator can carry out their work without
the need to wear safety glasses during most of the cutting process.
The shield is raised and lowered directly from the control panel.
Fumes and dust generated during cutting are removed by an
electronically controlled extraction system. The operator can use the
pre-programmed operating cycles for individual extraction sections or
adjust their settings to suit a specific process, improving dust
extraction efficiency.
The STIGAL DYNAMIC is equipped with WRYKRYS CAD/CAM software, which
enables part design and cutting path preparation. Based on the
prepared design, the software automatically generates the control code
and transfers it to the machine’s control system. The NESTING module
further optimises the arrangement of shapes on the sheet metal,
allowing more efficient material use and reducing waste. As a result,
the STIGAL plasma-gas cutting machine is suitable for both
single-piece and series production.
Technical specifications of the STIGAL DYNAMIC plasma-gas cutting
machine
- maximum cutting thickness (oxygen): 60 mm
- maximum cutting thickness (plasma): 25 mm
- work table dimensions: 3000 x 2000 mm
- feed speed: 22 m/min
- torch height adjustment type: voltage
- positioning accuracy: ± 0.05 mm
- programming format: G-CODE
- drive system: AC servo drives (4 pcs. )
- double-sided drive on the X-axis
- power consumption: 5500 W
- power supply: 400 V; 50 Hz
Equipment of the STIGAL plasma-gas cutting machine
- CNC controller
- CAD/CAM software with NESTING module: WRYKRYS
- plasma source: CEBORA PLASMA PROF
- automatic cutting parameter selection function
- vertical anti-collision system (WUA)
- dual piercing system (DPS)
- dynamic material detection system (DDM)
- dust and fume extraction system (ECTS)
- spark shield
- hardened and ground steel guideways
(The technical parameters given may differ slightly from reality. A
verification with the actual capabilities of the offered machine is
required.)
Poland
58-56 Jelenia Góra 
