ITALMEC TSR 300/1+6 wire drawing line was built in 2020 in Poland by
EJP Italmec Sp. z o.o. The purpose of the line is to reduce the
diameter of various types of wire, i.e. steel wire or welding wire, by
pulling it through a series of rollers. This process is performed
fully automatically, thanks to the use of two additional devices – a
wire pay-off and a wire coiler.
The wire drawing line consists of the following parts:
1. ITALMEC TSR 300/1+6 wire drawing machine
2. ITALMEC SB2C vertical static wire pay-off with compensator
3. ITALMEC AHSC 30 horizontal static wire coiler
The ITALMEC wire pay-off with rotating arm precisely unwinds material
from spools, coils or racks towards the drawing machine without
stopping it. It is equipped with a special device that stops the
machine in case of wire breakage and a compensator that accumulates
the amount of wire necessary to stop the machine without wire breakage
when a knot is detected. After each reduction, the wire is wound onto
one of seven drums. The finished product with the reduced diameter is
confectioned directly onto a carousel or stand.
Technical data of the individual parts of the ITALMEC TSR 300/1+6 wire
drawing line
Dry drawing machine
- year of manufacture: 2020
- material type: low and high carbon steel wire, CO2 welding wire, sub
arc wire, flux cored wire
- number of drums: 7
- maximum inlet wire M6151405 diameter: 2.5 mm
- maximum outlet wire diameter: 1 mm
- capstan diameter: 300 mm
- sensor control and dancer arm control
- safety protection in accordance with current standards
Vertical wire pay-off
- year of manufacture: 2020
- wire diameter range: 1-3.5 mm
- maximum external diameter of spool, coil or stand: 1000 mm
- maximum operating speed: 3 m/s
- compensator
- device that stops the machine in the event of wire breakage
Horizontal wire coiler
- year of manufacture: 2020
- material type: low-, medium- and high-carbon wire
- capstan diameter: 300 mm
- maximum wire diameter: 5 mm
Poland
