ID3265 Adler B50 year/Year of construction 2020 approx. 1500 hours/ hours 3.1 t Well drilling rig (well construction and geothermal energy up to 100 m), with trailer for drilling rig up to 3.5 t, standpipe with auger for pre-drilling, 110 m flushing drill pipe on steel pallet, complete maintenance was carried out at the end of 23. The machine was fitted with a new drill head from Eurodrill at the end of 2013 for approx. 20,000 euros. Water well drilling rig (well construction and geothermal energy up to 100 m), with trailer for drilling rig up to 3.5t, standpipe with auger for pre-drilling, 110 m directional drill pipe on steel pallet, complete maintenance was carried out at the end of 23. At the end of 23, the machine received a new drill head from Eurodrill for about 20,000 euros.
ID3208 Unimog 405/12 year/Year of construction 2000 10360 hours/hours – 71.100 km Unimog with Nordmeyer DSB 2/6 drilling rig, auger pump, overhauled in 2020, maximum crown load 100 kN, feed 60 kN, drilling cable winch 19 kN, power flushing head 7 kNm, crushing device 11 kNm, cable impact device (cable pulling force 30 kN, drilling load 5 kN, stroke 400 mm) Unimog with Nordmeyer DSB 2/6 drilling rig, screw pump, overhauled in 2020, maximum crown load 100 kN, feed 60 kN, drill cable winch 19 kN, power rinsing head 7 kNm, crushing device 11 kNm, rope impact device (rope pulling force 30 kN, drilling load 5 kN, stroke 400 mm)
ID3274 Sandvik Ranger 500 with HLX 5 T Hammer approx. 6000 hours/hours Hammer approx. 3000 hours/hours Machine with fire damage, cabs burnt out, otherwise everything is in order Machine with fire damage, driver's cabs burned out, otherwise everything is fine
ID3203 Wellco-Drill WD500 year/Year of construction 1994 approx. 2780 hours/ hours Drilling rig, crown regulating load 100 kN, crown extraction load 100 kN, hydraulic power jetting head (torque 10,000 Nm), drilling pressure max. 55 kN, tractive force 55 kN, interception device max. 219 mm, 2 winches, centrifugal pump, piston pump Drilling rig, crown control load 100 kN, crown exception load 100 kN, hydr. Power flushing head (torque 10,000 Nm), drilling pressure max. 55 kN, tensile force 55 kN, interceptor max. 219 mm, 2 winches, centrifugal pump, piston pump
ID3202 Wellco-Drill WD80 approx. 3110 hours/ hours Drilling rig, Hatz 3-cylinder diesel engine, fully hydraulic cylinder feed, flushing drill head - reinforced version, drive pin and pulling bell, rod catching device, centrifugal pump, cable winch, 4 hydraulic support cylinders, control panel, machine has been general overhauled (the control blocks have been completely renewed, the chain profile is new, the interceptor is new, the drill head has been completely overhauled, all possible wear parts have been renewed, all hydraulic components have been overhauled) Drilling rig, Hatz 3-cylinder diesel engine, fully hydraulic cylinder feed, directional drill head - reinforced design, drive journal and drawing bell, linkage interceptor, centrifugal pump, winch, 4 hydraulic support cylinders, control panel, machine has been completely overhauled (the control blocks have been completely ren ...
