Technical data baler:
Manufacturer Avermann Maschinenfabrik GmbH &
Co. KG, Germany
Type AVOS 1410-45/80
Year of construction
2009
Operation hours 22,029 hours, as of December 2025
Press
power main press 80kN
Specific press force 103,9 N/cm²
Feed
channel 1,400 x 1,000 mm
Theoretic cycle time 12 sec
Theoretic
throughput capacity 300 m³/h
Bale size 1,100 x 750 (w x h), the
length is variable
Drive power 45 kW
Connected load 75
kW
Tying system 4-fold, vertical, fully automatic
Throughput
capacity at a
bulk weight of 30 kg/cbm approx. 6,0 t/h
bulk
weight of 50 kg/cbm approx. 10,5 t/h
bulk weight of 100 kg/cbm
approx. 17,5 t/h
Bale weight with a bale length of approx. 1.2 m
up to 600 kg, depends on material
SPS controller Siemens
S7-300
Operating panel pulsotronic
Baler dimensions built up
8,610 x 2,400 x 3,835 mm (l x w x h)
Transport weight baler
approx. 16 t
Special equipment:
Wear-resistant floor made
of HARDOX steel
Special press ram for pressing ?difficult?
materials and loose bulk materials with small grain sizes
Control
cabinet air conditioning
Machine foot elevation 200
mm
Remark:
The machine was serviced and partially
overhauled in our workshop. The following work was carried out and
parts replaced:
? Dismantling of the press ram, disassembly
into individual parts, reconditioning of the mechanics, replacement of
the following plastic wear plates and rails:
o Plastic wear rails
left/right under the press ram
o Plastic wear rails left/right
above the press ram
o Plastic main wear plate (support plate) in
the centre under the press ram
? Steel guide rails on the
left/right in the frame
? Replacement of the entire base plate,
four-piece, made of wear-resistant HARDOX steel
? Wire inlet rails
in the press floor newly welded and smoothed
? Replacement of the
O51251246 counter blade, two-piece, in the frame
? Adjustment of
the blade gap to approx. 2.5 mm
? Dismantling of the binding and
twisting unit, disassembly into individual parts, loosening of the
mechanics, replacement of all deep groove ball bearings and axial ball
bearings on the twisting shafts, wire blades cleaned and readjusted,
chains greased and tensioned
? Support roller in front of the
twisting shafts replaced
? All hydraulic hoses replaced
? Oil
filter and air filter replaced
? Main hydraulic cylinder checked
for leaks
? The hydraulic oil is only one year old, has been
chemically analyzed, is still in good condition, and has therefore not
been changed but can continue to be used.
? General maintenance
work carried out
Finally, the press was subjected to a
machine test in manual and automatic mode
