Used multi-spindle machine INDEX MS36E built in 1996 including a lot
of accessories (collets, synchronizer guns, interchangeable wheels,
various working curves, etc.)
The plant is virtually ready for dispatch, in a dismantled state for
inspection. For photos, technical data and a list of accessories, see
Appendices. It has no major defects, is basically ready for operation,
only the rubber hoses should be changed before commissioning and the
coolant-lubricant system should be thoroughly cleaned and rinsed
throughout.
Accessory listing MS36E
Iemca Loading Magazine
Oil filter system (+3 rolls of filter paper)
Collets Synchronizer Clamps
(sentences)
Ø 24 Ø 16
Ø 26 Ø 20
Ø 27 2x Ø 23
Ø 28 2x Ø 26
Ø 30,5 2x Ø 27,5
Ø 31
Ø 32 div. jaws
Ø 33 for 3-jaw chuck
Ø 34
Ø 36
SW 24
1x spindle stop (currently layer 4)
3 sets of rod guide tubes
Various reductions for feed pipes
Various interchangeable wheels for circumferential tool holders
Various working curves
Cross-editing:
Various cross tool basic holder Zürn (7x narrow / 4x wide)
Div. Querschwerkzeug-Grundhalter Göltenbodt
2x Swiss-swivel device
Multi-sided turning device
Grease thread rolling head + various thread rolling
Longitudinal machining:
Threading device
Total. 7 longitudinal tool holders fixed
2x longitudinal tool holder circumferential
Various drive shafts and intermediate shafts
Thread milling device
Rear piercing device Göltenbodt
Synchronous acceptance with pliers and 3-jaw chuck
Germany
