variable speed, table can turn 360° table can tilt  ...

• more information

 ...

• more information

Boat accessories, ship accessories, spreader schooners, mooring schooners, fenders, lifeline cushions, railing schooners, boats, ships -approx. 180 positions boat accessories - see photos -we can send you the complete photos of the positions - will only be sold complete  ...

• more information

7TH & 8TH AXIS POSITIONER (CUSTOM) We provide industrial robotics and engineering solutions as well as custom positioner production according to your project needs. Please contact us for further information.  ...

• more information

Table load 35 to . tischdurchmesser 3,000 mms ...

• more information

Table load 30 to . table diameter 3,000 mms ...

• more information

Hydraulic fork positioner 550-2000 mm Fork positioner hydraulically by 550-2000 mm, Stacker, has been in use at 2.5 to can be mounted but on any truck, mast, front loader, etc, with integral Sideshift. Adapter plate with mount slots for cultivation. Dimensions available upon request. Adapter plate surface area approx. 715 x 650 mm. Valve block hydraulic pump can be supplied. Sale and mistakes are expressly reserved. Service/spare parts by MATEC CH-4900 Langenthal/DE-79618 Rheinfelden MATEC system + technik GmbH Mechanical engineering Eisenbahnstrasse 25 CH-4900 Langenthal/Switzerland Tel. 0041 62 966 18 32 Fax 0041 62 966 21 12

Non-contact position measuring system Manufacturer: Dornier Type: I-W-A Anwendungsgebite are: Axial and radial shaft vibration measurements Monitoring of measuring tolerances Determination of deformation and displacement Measurement of wave and eccentricities Roundness measurement Valve position measurement Thickness measurement Accessories: various transducer and mounting plates Evaluation electronics Connection cable Operating instructions Calibration curves Condition: used More info: see also photos All information without guarantee

Accuracy: 0.7 mm Application: Production and montagelinins, quality control Location: Rüsselsheim The measurement is based on the analysis of surface curvature. The deformation is detected by the detector built into the scanning head. During the measurement, the image of the detector is converted into a point cloud using the control software. Each of the points describes the geometry using X, Y, Z coordinates. The system then enables personalized analysis and reporting. The scanners can also be purchased individually. Visit by appointment. Disassembly, transport and commissioning by specialist company optionally possible.

one fixed unit and one movable unit (X-travel: 3000 mm) both units have manuals clamps variable turning speed center height: 1000 mm max swing of workpiece: 2000 mm cap with both units: 6000 kg cap with one unit: 3000 kg  ...

• more information