Technical data baler:
Manufacturer MACPRESSE EUROPA S.R.L.
Typ
112
Year of construction 2002, partially refurbished in December
2025
Operating hours 44,590 hours, stand December 2025
Press
power main press 200 tons
Specific press capacity 16,5
kg/cm²
Feed channel 2,000 x 1,020 mm
Filling volume 2,65
cm³
Theoretic throughput rate 795 m³/h
Bale size 1,100 x
1,100 mm, length variable
Driving motor 2 x 75 kW
Tying system
5-fold horizontal, full automatic
Throughput rate at MSW approx.
48 up to 54 tons/h, depends on material
Volume hydraulic oil tank
3,100 l
Machine weight baler approx. 50,8 tons
Scope of
delifery:
1 piece baler MACPRESSE, type 111A
1 operating
manual with CE declaration, electrical and hydraulic circuit
diagram
Comments:
The machine was serviced and partially
overhauled in our workshop. The following work was carried out and
parts replaced:
? Hydraulic oil tank emptied and
cleaned
? Oil and air filters replaced
? New hydraulic oil
filled
? All hydraulic hoses replaced
? Press ram dismantled,
broken down into individual parts, mechanics made operational
?
Front two main rollers replaced
? Knives on the press ram
replaced
? Main hydraulic cylinder dismantled, disassembled,
cylinder tube and piston rod checked, complete seal set replaced
?
Counter knife in the frame replaced
? Knife gap adjusted to
approx. 3 mm
? Upper steel guide rails in the frame on the left
and right replaced.
? Worn press base cut out, base plate replaced
with wear-resistant HARDOX steel.
? Binding and twisting unit
dismantled, broken down into individual parts, mechanics made
functional, all twisting shafts and ball bearings replaced.
? All
wire rollers in the needle heads replaced
? Wire knives cleaned
and readjusted, chains greased and tensioned
? All wire deflection
rollers made operational
? All door contact switches
replaced
? Wirbulator device dismantled, disassembled and made
operational
? General maintenance work carried
out
Finally, the press was subjected to a machine test in
manual and automatic mode, see our video for the machine function
test.
The documentation (BA, CE, electrical/hydraulic circuit
diagram) is complete. Viewing is possible by appointment. We accept no
liability for the technical specifications or any errors.
Olanda
NL 
