ILLIG RDM75K Thermoformer age 1998, refurbished in 2019 with Siemens
S5 PLC Controls, used only for ca. 50,000 hrs, Consisting of:, ELAU B1
Display with Touchpad controls Thermoformer with auto-start facility
Indramat Servomotor Indexing Max. material width 750 mm Max. Indexing
length 480 mm Top & Lower heaters, total connected load top & bottom
heaters 111.3 kW Auto Transport Rail Spreading for PP Sheet Sag
Control Max. Forming Area 700 x 450 mm Hydraulic Cylinder Plug Assist
with Bosch Rexroth Hydraulic Power Pack, completely Overhauled in 2019
Max. Part height 150 mm Max. Mold closing force 25,000 daN Auto
Lubrication system Siemens S5 PLC Controls New original ILLIG/ RITTAL
Control Cabinet Cooling System added in May-2023., Brief refurbishment
details are as follows:-, - Illig replaced the main camshaft with a
new reinforced main camshaft & the chassis on which the shaft under
the mold is mounted was reinforced as well i.e. a Major upgrade to the
Forming Station., - During the Upgrade, a new Hydraulic Pump was
installed, the old pump was reconditioned and is included as a spare
unit. A report for the maintenance of the complete Hydraulic System is
available., - A new Rittal Control Cabinet cooling unit, supplied by
ILLIG was added in May-2023, - A copy of the Software is also
available on a USB Drive., No Tooling or Format Parts are included
with the Line., Max Stacking Area: 750 x 350 mm, Min dia. of product:
Ø 40 mm, Max dia. of Product: Ø 150 mm, Total Drive Rating: 19 kW,
Compressed Air: 0.2 L at 6 bar, approximately, Output rate of Product
Stacks: 1200 Stacks/ hr, Max length of Product Stack: 730 mm, Max
height of Formed Product: 150 mm, Min Height of formed product: 25 mm
Germania
enger 
