pressure:1000 t
table length:4000 mm
table width:1600
mm
Controls:SIEMENS S7-1500F
PRESS DESIGN:.
- frame
design : Transfer press :.
- Drive type : mechnical :.
-
openings in uprights : yes :.
- opening in table : yes :.
- moving bolster : yes :.
- number of tables:2
PRESS
FORCES:.
- total force (nominal):1000 to
PRESS TABLE:.
- clamping surface (left-right):4000 mm
- clamping
surface (front-back):1600 mm
- height above floor level:600
mm
- autom. tool clamping device : yes :.
RAM:.
-
stroke:400 mm
RAM (MECHAN. PRESS):.
- ram adjustment:300
mm
- ram adjustment:100 mm
- number of strokes min:8
/min
- number of strokes max:50 /min
- hydraulic overload
protection : yes :.
TOOL ASSEMBLY DIMENSIONS:.
- shut
height (stroke down, adjustment up):900 mm
- shut height (stroke
down, adjustment up):766 mm
- distance between columns
(H-frame):4250 mm
- Free passage between side columns
(width):1800 mm
- tool weight max.:20000 kg
TRANSFER
SYSTEM:.
- Inner width clamping rails closed max.:500 mm
- Inner width clamping rails open max.:1300 mm
- distance
between tools, stroke from:0 mm
- distance between tools,
stroke to:800 mm
ELECTRICAL SPECIFICATIONS:.
- total power
consumption:200 kW
- mains power supply:350 kVA
- mains
voltage:400 V
- mains frequency:60 Hz
DIMENSIONS / WEIGHTS:.
- space requirements length:7500 mm
- space requirements
width:4800 mm
- height above floor level:7360 mm
- height
under floor level:4000 mm
- total weight approx.:250000
kg
ATTACHMENTS FOR PRESSES:.
- light barrier : yes :.
- cutting impact damping system : yes :.
- autom. tool
clamping device : yes :.
- hydraulic overload protection : yes
:.
- transfer system : yes :.
Description of
condition :
New transfer press! Stored. Never G6358715
assembled.
Complete with electronic beam transfer system,
0-800 mm transfer step and 500-1300 mm distance between transfer
beams. Lifting stroke = 0-150 mm.
2 units moving bolster ,
T-shaped-front travel.
Maximum total tool weight: 20,000 kg, upper
section: 10,000 kg.
The different specifications for the
installation height result from the installation or removal of the
table and ram plates. The different specifications for the ram
adjustment refer to operation with or without the transfer
device.
Ram weight compensation via pneumatic cylinders. Automatic
pressure setting with setpoint from the tool
memory.
Lubrication: Main bearings and gears are continuously
lubricated by a circulating lubrication system.
LED tool room
lighting. 2 auxiliary control panels, scrap deflectors, press force
measuring device, KTI vibration dampers.
Almanya
