Specifications:
Control SEICOS (Sigma) 16 M
Pallet clamping surfaces 400 x 400 mm
Travel x-y-z 600 – 580 – 580 mm
Tool changer 61 places
Speed 35 to 12,000 rpm
Feed rate 1 to 50,000 mm/min
Rapid traverse 50,000 mm/min
Weight 11400 kg
Further technical data available on request
The machine ran like this for us until the end.
All axes are running, tool magazine OK.
The tool changer is running, it just has to be made operational.
! Only the spindle has a fault and only runs above approx. 3,100
rpm.
The cause is either a cable problem from the controller,
or the spindle in itself has a problem at the lower speeds.
O51263796
The machine has a Fanuc control system that is operated via the SEICOS
interface.
All control parts, regulators are Fanuc.
The machine has a 2-fold plate changer that also runs.
The table can be adjusted in 1° steps.
The machine can currently still be viewed under power.
Germany
