Used Chain Conveyor Belt
Manufacturer: PAAL
Type: KEM 1500
Year of Make: 2005
specifications:
Conveying width: approx. 1,500 mm
Belt run: approx. 3,100 mm horizontally underfloor,
then rising below 28° over a length of approx. 6,000 mm,
Descending below 10° on the remaining length and conveying into the
press
Conveyor belt speed: 0.27 m/sec.
Conveyor belt drive power: 4.0 kW
Sidewall heights
- in the horizontal part: 527 mm
- in the climbing section: 777 mm
Operating voltage: 3 x 400 VAC / 50 Hz / N / PE
pre-assembled as far as possible, consisting of:
- Strip frame in solidly welded profile steel and sheet steel edge
construction,
- Additional sliding guides below the belt support profiles in the
horizontal and riser sections to absorb heavy loads,
- Conveyor belt (quality: EP 200/2 2:1) with lateral 20 mm high
T-studs for sealing the belt stringers,
- Belt routing in a neutral zone to avoid stretching tensions,
- Chain type M-80 with case-hardened bushings, bolts and rollers,
- Chain straps with reinforced carrying brackets and partly with
replaceable, lateral plastic chain protectors,
- chain string breaking load 8 t, (16 t static load with a nominal
width of 1.2 m to approx. 700 kg per m of strip length),
- Belt support profiles at intervals of 250 mm torsionally B51239235
stiff with 4 screws each attached to the chain plates without belt
intermediate layer,
- Carriers above the belt made of angle steel,
- Bevel gear drive motor with integrated brake,
- Drip oilers for uniform lubrication of the chains,
- Conveyor belt supports made of sectional steel construction with
height adjustment,
- Emergency stop switch on the side of the conveyor belt and cable
pull emergency stop above the conveyor belt in standard design,
- Start/stop switch on the rising conveyor belt scaffolding,
- Synthetic resin top coat in light blue according to RAL 5012
Germany
49324 Melle 
