FAGOR TSE2-1000-4000-1600 Transfer Press

pressure:1000 t
table length:4000 mm
table width:1600 mm
Controls:SIEMENS S7-1500F
PRESS DESIGN:.
- frame design : Transfer press :.
- Drive type : mechnical :.
- openings in uprights : yes :.
- opening in table : yes :.
- moving bolster : yes :.
- number of tables:2
PRESS FORCES:.
- total force (nominal):1000 to
PRESS TABLE:.
- clamping surface (left-right):4000 mm
- clamping surface (front-back):1600 mm
- height above floor level:600 mm
- autom. tool clamping device : yes :.
RAM:.
- stroke:400 mm
RAM (MECHAN. PRESS):.
- ram adjustment:300 mm
- ram adjustment:100 mm
- number of strokes min:8 /min
- number of strokes max:50 /min
- hydraulic overload protection : yes :.
TOOL ASSEMBLY DIMENSIONS:.
- shut height (stroke down, adjustment up):900 mm
- shut height (stroke down, adjustment up):766 mm
- distance between columns (H-frame):4250 mm
- Free passage between side columns (width):1800 mm
- tool weight max.:20000 kg
TRANSFER SYSTEM:.
- Inner width clamping rails closed max.:500 mm
- Inner width clamping rails open max.:1300 mm
- distance between tools, stroke from:0 mm
- distance between tools, stroke to:800 mm
ELECTRICAL SPECIFICATIONS:.
- total power consumption:200 kW
- mains power supply:350 kVA
- mains voltage:400 V
- mains frequency:60 Hz
DIMENSIONS / WEIGHTS:.
- space requirements length:7500 mm
- space requirements width:4800 mm
- height above floor level:7360 mm
- height under floor level:4000 mm
- total weight approx.:250000 kg
ATTACHMENTS FOR PRESSES:.
- light barrier : yes :.
- cutting impact damping system : yes :.
- autom. tool clamping device : yes :.
- hydraulic overload protection : yes :.
- transfer system : yes :.
Description of condition :
New transfer press! Stored. Never assembled.
Complete with electronic beam transfer system, 0-800 mm transfer step and 500-1300 mm distance between transfer beams. Lifting stroke = 0-150 mm.
2 units moving bolster , T-shaped-front travel.
Maximum total tool weight: 20,000 kg, upper section: 10,000 kg.
The different specifications for the installation height result from the installation or removal of the table and ram plates. The different specifications for the ram adjustment refer to operation with or without the transfer device.
Ram weight compensation via pneumatic cylinders. Automatic pressure setting with setpoint from the tool memory.
Lubrication: Main bearings and gears are continuously lubricated by a circulating lubrication system.
LED tool room lighting. 2 auxiliary control panels, scrap deflectors, press force measuring device, KTI vibration dampers.