sheet width: 3100 mm
plate thickness: 4.0 mm
thickness at
Niro-steel: 2.5 mm
cutting angle adjustment: 1.0 °
back stop
- adjustable: 10 - 1000 mm
adjustment speed: 180 mm/s
down
holder: 21 Stück
strokes per minute: 18 - 31
oil volume: 160
L
Control: ELGO P8511
column arm: 200 mm
distance between
columns: 3050 mm
0: max. 300 bar
voltage: 400 V
main
drive: 9.0 kW
weight of the machine ca.: 4800 kg.
dimensions
of the machine ca.: 3660 x 2070 x 2140 mm
from a maintenance
workshop
Equipment:
- electro-hydraulic sheet metal shear
swing cut
- machine frame = all-steel welded construction
-
ELGO NC control model P8511, control panel at the front left
for
positioning the electro-motoric rear stop
target/actual position
value input possible
adjustment by three-phase motor via toothed
belt
- support table with ball rollers
there are recessed
grips between the table plates
- front finger guard
-
hydraulically acting sheet metal hold-down device
- 1x freely
movable foot switch
- emergency stop button at the front
-
movable H51251851 scrap switch
- original operating instructions
+ circuit diagram
Special accessories included:
- EHT
pneumatic sheet metal holding device for thin sheet metal cuts
-
1x EHT extra long side stop 3.000 mm with mm scale & support
foot
- 1x EHT extra long support arm with 3.000 mm with scale &
Support foot
- EHT additional support arms with mm
scale
The data for this ad was created with
ModulMWS - the software solution of LogoTech oHG.
