Technical data baler:
Manufacturer Presona AB
Type LP 50
EH1
Year of construction 2005
Operating hours 30,408 hours, as
of April
Number of pressed bales 198,059 as of
April
Pressing force main press 50 tonnes
Specific pressing
force 63 N/cm²
Theoretical throughput capacity 530
m³/hour
Throughput capacity under operating conditions 260
m³/hour
Dimensions of feed chute 1,250 x 1,100 mm
Bale
chamber volume 2.2 m³
Bale dimensions 1,100 x 720 mm, variable
length
Drive power 22 kW
Tying 5-fold vertical, fully
automatic
Throughput rates with a
bulk density of 30 kg/cbm 6
up to 7 tonnes/hour
Bulk weight of 50 kg/cbm 7 up to 9
tonnes/hour
Bulk weight of 100 kg/cbm 11 up to 14
tonnes/hour
Bale density (paper/newspapers) 400 to 550 kg/m³
Hydraulic oil tank capacity 600 litres
PLC control
Telemecanique TSX Micro
Schneider Magelis control
panel
Effective transport dimensions excl. baler 8,125 x 2,300 x
3,000 mm (L x W x H)
Transport weight press approx. 16
tonnes
Condition of the baler:
The machine was partial
overhauled in our workshop and general maintenance work was carried
out. After completion of the overhaul work, the press was tested
during operation and is available for sale at short
notice.
The following overhaul work was carried
out:
General work:
Machine cleaned, derusted, primed,
partially painted
Wire entry marks in the press channel
feed-throughs welded shut and smoothed
Hydraulic
unit:
Hydraulic oil tank emptied, tank cleaned, new oil
filled
Oil filter and air filter replaced
Leaky oil sight
glass on hydraulic oil tank replaced
All hydraulic hoses
replaced
Electrics:
English language installed in the
programme menu
Two key switches in the control panel
replaced
Control cabinet replaced
Signal lamp on the control
cabinet replaced
Flaps end switch replaced
Electrical system
of the turbulator replaced, connected and tested
Press
ram:
All four rollers removed from the press ram and
replaced
Main hydraulic cylinder dismantled, disassembled and
partially overhauled, cylinder tube honed, O6351246 complete seal set
replaced, leak test performed
All plastic wear pads on the press
ram replaced
Pre-press:
Both bearings on the pre-press
shaft replaced.
Both hydraulic cylinders dismantled, disassembled
and partially overhauled, both cylinder tubes honed, complete seal
sets replaced, leak test performed.
Scraper flap on the pre-press
replaced.
Binding system:
Two complete needles with wire
deflection rollers replaced
Needles adjusted and set
All wire
deflection rollers in the needle heads replaced
Drill fingers
replaced
Two drill shafts replaced
All 8 wear plates on the
Drillomat, under the drill fingers, replaced
Scope of
delivery:
Only the baler will be sold.
The documentation
(Manual, CE-declaration, electr./hydr.-drawings), are completely
available. Inspections are possible after agreement. We will not
assume liability for the given technical data and possible errors.
Holandia
NL 
