Linia do wytłaczania APV 125MP compounding line

maszyny do przetwórstwa tworzyw sztucznych / wytłaczarki

zażądać więcej zdjęć

Exapro S.A.S
[ profil dealera ]

4 place Marc Leclerc
49400 Saumur
France

dystrybutor maszyn członek od 2023

lista maszyn (4981)

Wyślij zapytanie

Dodaj do listy oglądania

Wyślij zapytanie

Numer pozycji: 162905398	Ilość: 1	Data: 28.04.2024
Rok produkcji: 1990	Lokalizacja: Francja

Cena:	142,000 EUR
Producent:	APV
Model:	125MP compounding line
Typ maszyny:	Linia do wytłaczania
Opis:	Linia do wytłaczania APV 125MP compounding line używana maszyna Extruder is missing electronics and it is not in running condition. Barrel 30D The barrel was opened for inspection of the liners and shafts, the hydraulics function correctly. Liner 1. Feed, 2.5D good condition Liner 2. Inter, 5.0D good condition Liner 3. Inter, 5.0D good condition Liner 4. Inter, 5.0D good condition Liner 5. Inter 5.0D good condition Liner 6. Inter 2.5D good condition Liner 7. XLT Discharge 5D good condition. Feed and return lines were removed and compressed air fed into circulation blocks. All blocks were found to have good flow. Pipework is in good condition with all solenoids present. All control thermocouples and melt thermocouples are in place but could not be tested due to condition of electrics. All the heaters are in place but could not be tested due to the condition of electrics. The barrel is in very good overall condition. Shafts All elements are in good condition with very little visible wear. Customer has numerous spare elements and 2 sets of new shafts Spares held by customer, Feed Screw 1D 1D 18 off Feed Screw 1.5D 1D 14 off Feed Screw 0.75D 1.5D 6 off Feed Screw D/4 1.5D 4 off Tight Helix Feed Screw 1D 5 off Feed Screw â XLT transition 1.5D 1D 5 off Orifice plugs D/4 4 off Paddles D/4 69 off XLT FS 117mm 3 off XLT FS 156.25mm 6 off XLTD FS 156.25mm 3 off End pins 2 off Set of E4461673 shafts 2 off Gearbox The motor coupling and the shaft couplings were disconnected from the gearbox. No excessive backlash, end float or radial movement is present in the input or output shafts. Timing is ok. There are no visible oil leaks. Electrical panels The extruder electrics/electronics have been badly vandalized and as far as I can see very little can be salvaged and a new panel would be needed in order to run the extruder and feeders. The original panel controlled 8 feeders and all ancillary equipment and ran on Siemens S5 see below photos. seller offer No. resale P91004100
Seller-item-No.:	P91004100

Udostępnij tę maszynę na Facebook: