FARSOON eForm D Printers

Laser printer for plastics FARSOON eForm 3D built in 2017. The printer is offered with complete equipment for preparing powder and cleaning prints. The equipment was used to a small extent for about 12 months, it worked for about 2000 hours. The device operated in a gas shield from a cylinder.

Complete with printer: 8 nitrogen regulators.

Technical data of the FARSOON eForm 3D printer:
- open control software: any modification of printing parameters
- laser type: CO?
- laser power: 30 W
- dimensions of the printing chamber (W × D × H ) : 250 × 250 × 320 mm
- single print layer: 0.06 ~ 0.3 mm, adjustable
- maximum creation / build speed: 0.8 l / h (depending on the material)
- precise scanning system: Galvo
- scanning speed: 7.6 m / s
- power requirements: 380 VAC, 50/60 Hz, 16 KVA, three-phase five-wire
- maximum temperature in the chamber: 190 degrees C
- heating element: golden infrared heater
- thermal field control: 8-zone heater and intelligent temperature control systems
- temperature regulation, continuous monitoring and optimization of surface temperature in real time
- 64-bit operating system: Windows 7
- user interface mode: exchangeable expert mode and production mode
- system control software: FarsoonMakeStar, open platform control interface
- data file format: STL
- the most important software functions: manual and automatic mode, modification of compilation parameters in real time, three-dimensional visualization, diagnostic functions
- printer dimensions (W × D × H ) : 1735 × 1225 × 1975 mm

Additional equipment
- external chiller: INDUSTRIAL CHILLER CW 6000

Material (plastic) used in powder form:
- FS 3300PA (powder based on PA1212)
- FS 3401GB (filled with glass ball)
- FS 3400CF (filled with carbon fiber)
- FS 3250MF (filled with mineral fiber)
- FS 4100PA (powder PA11)