sheet width: 3230 mm
plate thickness: 2.5 mm
thickness at
Niro-steel: 1.5 mm
no. of strokes: 28 - 42 Hub/min
cutting
angle: 1.60 Grad
table height: 820 mm
distance between
columns: 3540 mm
Control: ELGO 87P
engine output: 6.8
kW
weight of the machine ca.: 3410 kg.
range L-W-H: 4070 x
2070 x 1400 mm
from a maintenance workshop
including special
accessories ()
Equipment:
- robust / motorized swing cut
guillotine shears
- break-proof, torsion-free steel welded
construction
- compact and clear machine design
- NC
electro-motorized back stop
- including NC ELGO TYP 87P digital
control unit
adjustable from the front right
with
target/actual value position input
continuous adjustment over the
entire travel range
rough adjustment via push buttons
protection of the limit values with limit switch
- Duo-Cut drive
with two dynamic, powerful gear motors
- support table with
recessed grips
- hold-down bar with hard rubber strip
-
all-steel knife with two cutting edges
- selector switch for
single and continuous H51251851 stroke
- 1x freely movable foot
switch
- safety device at the rear
- original operating
instructions
Special accessories included:
- pneumatic
sheet holding device for thin sheet metal cuts
- 1x extra long
side stop, including support foot + digital stop
- 2x extra long,
front support arms
with SLIDING mount - for easy
moving
The data for this ad was created with
ModulMWS - the software solution of LogoTech oHG.
德国
Ahaus 
