carter 고무 기계 사용 판매를 위해

Qty 1 x Carter MK3+ Banbury internal mixer,  chamber volume 90L,  batch weight approx 85kg,  2 wing tangential rotors,  drilled sides, roller bearings,  hydraulic drop door with linear actuator and spade latch.  F type dust seals.  With 325kw, 1070rpm, 715A, DC variable speed motor and controls.  Pneumatic hopper.  Complete with hydraulic unit, lubrication unit etc and in good condition (previously used for mixing coloured compounds). 

Refer to code 1008 in your request More information on our web page G3 Mixing Technologies - G3 STOCK or LinkedIn G3 STOCK Used machine, possibility to be purchased "as is" without warranty, or completely rebuilt and guaranteed as new machine.

Key data: 160 liter

Qty 1 x Carter MK6 banbury internal mixer, Original year of manufacture 1995, New body 2012, Mixing chamber volume: 160L, Batch size: approx 150kg, Pneumatic hopper, 2 wing tangential rotors, S.S.A type dust stops, Hydraulic drop door discharge with linear actuator and spade latch, Pneumatic hopper, David Brown Semi-unidrive gearbox (1300rpm input, 50.4rpm output). Gearbox ratio 25.8:1, Power Rating 600kW. Complete with hydraulic powerpack and lubrication unit. Only used for softer compounds and in good condition. Currently without motor or electrical controls (can be quoted if required).

Qty 1 x Carter MK6 direct drive Banbury internal mixer, Serial no. 237/11 (New chamber/hydraulic hopper in 2011/12), Hydraulic hopper, Chamber volume: 160L, 2 wing rotors, SSA type dust stops, hydraulic drop door with linear actuator, pneumatic oil injector fitted to end frame, hydraulic hopper, PIV semi unidrive gearbox (28:1 ratio), 310/620kW power rating, 728/1484rpm input speed, 26/53rpm output speed. Currently fitted with fixed speed motor fitted - 355kW, 744rpm to give rotor speed 26.5rpm. Complete with lubrication unit, hydraulic unit, electrical controls etc and in very good condition (inspection report carried out by Farrel available on request).

Frequency-controlled heating laboratory press with force measuring device -Pressure 20 KN / 2 tons -Pressing area 220 220 mm -Maximum pressing force at 220 220 mm: 41 N / cm² -Hot press with moveable lower pressing plate, electric drive with gear reduction, force measurement is carried out by means of strain gauge sensor -Heat output approx. 1 KW -Plate temperature 120 ° C -Dwell time / duration of laminating: 1-10 s -Pneumatic connection 6bar required -Power supply 400 V, 16 A -Sliding table with integrated positioning pins, lower pressing plate, pneumatic drive -Pressing panels with switchable integrated vacuum channel -Electrical control system integrated with PLC control display in the front panel of the machine -Side channel pump to generate the vacuum