sheet width: 3050 mm
plate thickness: 3.0 mm ST
pre-bending
capacity: 3.0 mm ST
upper roll diameter: 170 mm
lower roll
diameter: 170 mm
side roll diameter: 180 mm
Control: konv.
0: 380 V
total power requirement: 3.0 KW
weight: 4250
kg
In good condition
With new rubber-coated top roll ()
Also suitable for bending non-ferrous metals
Equipment:
-
Electro-hydraulic 3-roll bending machine
- Asymmetrical roll
arrangement
- Electro-motor-driven side roll adjustment
Including digital position display
- Manual bottom roll
adjustment
Via hand crank
- Including conical bending
device
Inclined bottom roll and side rolls
Parallel
alignment in any side roll position
- Hardened rolls SAE 1050 CK
45
- Manual folding storage for removing closed pipes
Top
roll must be raised before opening the storage (e.g.,
forklift/crane)
- Safety device
- Connection cable +
connector
- 4-way foot switch
2 buttons for side H51251851
roll movement (up/down)
2 buttons for roll movement
(left/right)
With 4x new foot switch covers
- Operating
instructions (English)
Special accessories included:
-
Brand new top roller with plastic/rubber coating
Suitable for
bending non-ferrous metals
Such as copper and
aluminum
The data for this ad was created
with ModulMWS - the software solution of LogoTech oHG.
Німеччина
Ahaus 
