EHT TSS 4-30 Гідравлічні листові ножиці

sheet width: 3100 mm
plate thickness: 4.0 mm
thickness at Niro-steel: 2.5 mm
cutting angle adjustment: 1.0 °
back stop - adjustable: 10 - 1000 mm
adjustment speed: 180 mm/s
down holder: 21 Stück
strokes per minute: 18 - 31
column arm: 200 mm
Control: ELGO P8721
oil volume: 160 L
0: max. 300 bar
voltage: 400 V
main drive: 7.5 kW
weight of the machine ca.: 4800 kg.
dimensions of the machine ca.: 3660 x 2070 x 2140 mm
** from a maintenance workshop
** good condition (!!)
Features:
- Electro-hydraulic sheet metal shear (swing cut)
- Machine frame = all-steel welded construction
- ELGO NC control system, Model P8721, control panel on the front left
* for positioning the electrically driven backgauge
* Target/actual position value input possible
* Adjustment via three-phase motor using a toothed belt
- Support table with ball bearings
* Recessed handles between the table plates
- Front finger guard
- Hydraulic sheet metal hold-down devices
- 1x side stop with mm scale
- 2x front support arms with mm scale
- 1x freely movable foot switch
- Emergency stop button at the front
- 1x movable / rear scrap deflector
- Original operating instructions
** Special accessories included:
- EHT pneumatic sheet metal holding device for thin sheet metal blanks
The data for this ad was created with ModulMWS - the software solution of LogoTech oHG.