max. workpiece diameter:29 mm
min. workpiece diameter:26
mm
workpiece length:66 mm
the system was originally
delivered for the following workpiece sizes: diameter 26mm - 29mm
length 65mm - 66mm
Changing parts in the clamping device,
handling, etc. would probably result in diameters of up to approx.
Ø50mm
Total length will probably be almost 400 mm possible with a
few conversions.
Also dependent on tool lengths, machining lengths
on the component, etc.
Workpiece: Piston pin
Drawing
number: WHT 000 718, WHT 000 718 A
Workpiece dimensions (Ø,
WxH): Ø26 x 66; Ø29 x 65
Length: 66 or 65 mm
Material:
17Cr3
Quantity: xxx parts / year
Cycle time: 5 sec.
However, workpiece lengths up to 600mm are manageable. The
machining diameter can be adjusted if the appropriate tools are
available. The clamping station can currently only accommodate this
product. However, this can be adapted by changing the clamping prisms.
The parts that were typically produced on this machine left the system
via a chute onto a conveyor belt. If longer parts were to be
manufactured, this would need to be examined in
detail.
Texte, Bilder, Grafiken, Layout, Strukturen und
Algorithmen etc. unterliegen weltweitem Urheberrecht.
Unerlaubte
Verwendung der Daten, werden sowohl strafrechtlich als auch
zivilrechtlich verfolgt.
Das ausschließliche Urheber- /
Nutzungsrecht dieser Daten wurde nachfolgender Person
eingeräumt.
Copyright © 2005-2025, Josef Weber. All rights
reserved.
