tube diameter: 6 - 28 mm
wall strength: 2 mm
bending radius
min.: 2 x D
Control: IPU 20
bending radius max.: 5,0 x D
mm
bending angle max.: 190 °
arbor length: 3000
mm
operating pressure: 180 bar
hydraulic motor: 4
kW
weight of the machine ca.: 900 kg
dimensions of the machine
ca.: 3,8 x 1,1 x 1,3 m
Condition: ready for operation:
Video
available on our website.:
Electric 400 Volt:
Bending
segments: 15-20-26-28 mm
Bending mandrels: 4
Operation panel:
0,5 x 0,6 x 1,03 m
Double Foot pedal:
Machine manual:
Semi-automatic electro-hydr. mandrel tube bending machine with
PLC control for
20 angles and display in the control panel for
bending angle specification,
angle detection and angle
measurement via absolute value encoder, autom. tool
plate reset,
Turning device with digital display, hydr. quick chuck,
aut.
Mandrel lubrication, adjustable length stops.
Operating
modes: MANUAL and semi-automatic.
Control buttons: hydraulics on /
off, operating mode selection, clamp to / on,
clamp forward /
backward, mandrel forward / backward, bending forward /
backward
/, locking forward / backward, mandrel lubrication, turning device
forward / backward, plate reset, length stop forward, emergency
P51219061 stop.
The machine comes from a prototype construction
and was only used a little
until 2000. After that, the machines
of this department were sold. However, the
purchaser did not use
the pipe bending machine and therefore it has only stood
in the
warehouse and has not worked since then ((original paint).
Please
notice that the price of a new machine today is over €
60.000,--.
Machine dealer with own stock of 1600
m².
The data for this ad was created with
ModulMWS - the software solution of LogoTech oHG.
Niemcy
Bünde bei Bielefeld 
