Set up for ALU/PVC and ALU/ALU operation
Format range blister (W x L) min 50 x 22 mm / max. 156 x 115 mm
Drawing depth max. 10 mm
Output 15 - 55 forming cycles/min
Transport length 42-115 mm
Film width 100-168 mm
Forming film Ø max. 450 mm, core Ø 76 mm (PVC) / 150 mm (ALU),
mech. clamping
Cover film-Ø max. 240mm, core-Ø 76 mm, mech. tensioning
Splice Detection
Film feed after forming and sealing
Print mark control
Film stretching unit
Pin hole detection for form foil and lid foil, Visiotec VisioScan
MT-160/200
Heating plate station for PVC
Forming station with compressed air for PVC form foil, pre-equipped
for pre-stretching die
Mechanical forming station for ALU forming foil
Filling control VisioChrom HR 302A1 with own UPS
Perforating station (heated) for scoring the forming film between
the products to facilitate tearing off
Product feed, dedicated feeder, Uhlmann SimTab type 2.1. model
2000, for tablets/capsules
Without bad blister B51261182 reject, is pre-equipped in the
control system with ejection counter-check. Can be retrofitted on
request at extra cost.
Only 5,881 operating hours
Drive 400V/50Hz
Menu languages German / English, further languages on request
New!
Control cabinet installation (wiring) with new components on the base
plate
PLC B+R Automation, type X 20, touch panel (HMI) PPC 3100
Servo controller B+R Automation, type Acopos P3 incl. I/O modules
독일
