Technical data baler:
Manufacturer Presona AB, Sweden
Type LP
60 VH1
Year of construction 2015
Total operating hours, 30,143
hours, as of July 2025
Effective pump running time onl 6,527
hours, as of July 2025
Number of pressed bales 115,193 bales, as
of July 2025
Press force pre press 25 t
Main press force 60
tonnes
Specific pressing force 73N/cm²
Dimensions of feed
chute 1,500 x 1,100 mm
Filling volume / pressing cycle 2.7
m³
Theoretical throughput capacity 800 m³/hour
Throughput
capacity under operating conditions 350 m³/hour
Bale dimensions
1,100 x 750 mm
Drive power 37 kW
Tying 5-fold vertical, fully
automatic
Throughput capacity with a
Bulk weight of 50 kg/cbm
11 to 14 tonnes/hour
Bale weights 420 to 570 kg, depending on
material
Hydraulic oil tank volume 600 litres
Baler dimensions
assembled with hopper 10,100 x 3,750 x 4,310 mm (l x w x
h)
Transport dimensions excluding press 10,100 x 2,400 x 3,000 mm
(l x w x h)
Machine weight press approx. 20
tonnes
Condition of the press:
The press was
partially overhauled in our workshop and then tested in manual and
automatic mode.
The following overhaul work was carried
out:
Machine cleaned, partially derusted and partially
repainted
Hydraulic oil tank emptied and cleaned
Oil filter
and air filter replaced, new hydraulic oil filled
Press ram
dismantled and cleaned
All four rollers removed from the press ram
and replaced
Grease cartridges of the automatic roller lubrication
system replaced
Slide rails cut out from the press floor in the
press room
Underbody reinforced with welded sheets
New HARDOX
slide rails welded in
Wire station with deflection rollers for the
lower wire cleaned and made operational
Slide rails cut out from
the floor in the press channel
New HARDOX slide rails welded
in
Both side walls of the press channel dismantled, O6151246
derusted
Worn side wall plates cut out
Complete side walls
covered with new wear plates and welded
Main hydraulic cylinder
dismantled and disassembled for inspection
Piston rod replaced,
cylinder tube honed
Complete seal set replaced, pressure test
carried out
Vertical needle system for binding dismantled,
cleaned, wire deflection rollers made functional and
serviced
Chain cleaned, greased, chain tension
readjusted
Drillomat cleaned, wire knife, drill shafts and drill
fingers checked, retightened with torque and serviced
Machine
checked, general maintenance work carried out and press tested in
manual and automatic mode
Comments:
The press is sold
without a conveyor belt and without wire stations. Inspections are
possible after agreement. We will not assume liability for the given
technical data and possible errors.
네덜란드
NL 
