TEKA Cartmaster 焊接烟雾排风机

: 1860 m³/h
: Pressung 2.900 Pa
: 1,1 kW
filter surface area: 10 m²
: 72 dB(A)
: 400/50 V/Hz
: 665 x 1100 x 1495 mm
: 200 kg
- Hose arm 3 m, joints inside
- Filter cartridge: dust class M
- Pre-filter: baffle plate
- Current type: 3Ph+N+PE
The filter system
---------------------------------------
The mobile filter system of the Cartmaster IFA type is thanks to the automatic
Cleaning particularly suitable for welding work with unalloyed and
alloyed steels, galvanized material and aluminum with heavy smoke development.
It corresponds to the safety requirements for devices
Welding fume class W3 (high-alloy steels with alloy components > 30%
Nickel-based alloy).If used as intended, the system can be used for the
Recirculation mode used because the requirements for the
Exceptions according to TRGS 560 are fulfilled. That special
developed, dirt-dependent cleaning system ensures a good
cleaning behavior of the filter cartridge, so that an optimal suction
performance
is guaranteed throughout the operation. The cleaned particles
fall into a dust collection drawer from which they can then be disposed of.
The powerful spiral fan ensures even with saturated
Filter cartridges for a high volume flow.
The filter media
---------------------------------------
A baffle serves as a pre-separator for coarse particles.
The filter cartridge installed below (dust class M, degree of separation > 99%)
filters the finest smoke and dust particles. The cartridge is factory
coated which increases the service life.
The extraction arm
------------------------
The extraction arm can be moved with the 3 internal joints
Position spring support slightly and is in the set position
cantilevered. A throttle flap integrated in the extraction hood enables the
Flow rate setting.
The data for this ad was created with ModulMWS - the software solution of LogoTech oHG.