Technical data baler:
Manufacturer Presona AB
Typ LP 80 VHK
1
Year of construction 2012
Total machine operating hours
25,895 hours, as of July 2025
Pump operating hours, effective
14,135 hours, as of July 2025
Number of bales pressed 235,597
pieces, as of July 2025
Press power main press 78,5
tons
Specific press capacity 95 N/cm²
Press power of
pre-press 28 tons
Volume of pressing chamber 2,7 m³
Feed
channel1,500 x 1,100 mm
Theoretic throughput rate 930
m³/h
Throughput rate under operating conditions 410
m³/h
Bale size 750 x 1,100 mm
Driving motor 55 kW
Tying
system 5 fold vertical, 3-fold horizontal, full
automatic
Throughput rate with a bulk density of
30 kg/m³
approx. 9 to 12 tonnes/hour, depending on material
50 kg/m³
approx. 14 to 17 tonnes/hour, depending on material
100 kg/m³
approx. 16 to 25 tonnes/hour, depending on material
Throughput
capacity with MSW (Municipal Solid Waste) approx. 20 to 27
tonnes/hour, depending on material
Bale weight 450 up to 600 kg,
depends on material and bale length
Volume hydraulic oil tank
1,000 l
Baler dimensions built up with hopper 10,985 x 3,750 x
4,310 mm (l x w x h)
Transport dimensions only baler 10,985 x
2,300 x 2,900 mm (L x w x h)
Machine weight baler approx. 24
tons
Condition of the press:
The machine was partially
overhauled and serviced in our workshop and, once the work was
complete, tested in manual and automatic mode during
operation.
The following overhaul work was carried
out:
Machine cleaned, partially derusted and partially
repainted
Hydraulic oil tank emptied and cleaned
Oil filter
and air filter replaced, new hydraulic oil filled
Press ram
dismantled and cleaned
All four rollers removed from the press ram
and replaced
Wire station with deflection rollers for the lower
wire cleaned and made operational
Side guides removed from the
press ram, smoothed, mounted and readjusted
Main hydraulic
cylinder dismantled and disassembled for inspection
Piston rod
replaced, cylinder tube honed
Complete seal set replaced, pressure
test carried out
Vertical and horizontal needle O51251246
system for binding dismantled, cleaned, wire deflection rollers made
functional and serviced
Chain cleaned, greased, chain tension
readjusted
Drillomat cleaned, wire knife, drill shafts and drill
fingers checked, retightened with torque and serviced
Door contact
switch checked and partially replaced.
Emergency stop switch
checked.
Complete electrical wiring checked and partially
replaced.
Bearings of the wire guide rollers under the press
replaced.
New safety grilles for vertical and horizontal binding
manufactured and installed.
Machine checked, general maintenance
work carried out and press tested in manual and automatic
mode
Scope of delivery:
Only the baler will be
sold.
Comments:
The documentation (Manual,
CE-declaration, electr./hydr.-drawings), are completely available.
Inspections are possible after agreement. We will not assume
liability for the given technical data and possible errors.
荷兰
NL 
