ERREGI Tecnopress VR2/2 穿送车体压机

Throughfeed case clamp
Make: ERREGI
Type: Tecnopress VR2/2
New machine

Fast - Silent - Clean - Lean - Universal - Service by Wehrmann

Technical data:

 Self-positioning thru-feed carcase press

The load bearing structure of the machine consists of a double portal in welded tubular steel, inside of which the two mobile heads and the presser table run.

-The presser table and the mobile head are driven by motors.

- Each of the mobile head and fixed is fitted with three
horizontal pressure beams with programmable positioning
moved vertically by an electro mechanical system.

- The belt system is positioned on either side of the machine
to allow the carcase to be clamped equally well,
whether is his depth.

-The carcase transfer system is located at the bottom
of the bed and consists of an electro-welded steel structure
on which a closed loop belt rolls driven by an
inverter-controlled, non synchronous motor.

Once the piece of furniture is assembled on the preparation bench the operator starts the automatic cycle and the carcase enters the machine.
The reading devices which the machine is equipped with automatically determine the length and height of the workpiece and send this information to the PLC which positions the mobile head and the conveyor and stops the carcase in position .
The beam automatically move to the preset position; once the presser table, heads and the beam are all in position, the clamping cycle begins which can be either for carcases with dowels.

The clamping strength can be adjusted from the control console.
Once the pressing time has elapsed, or the operator has opened the machine, the carcase is fed out (unloading onto outfeed conveyor, optional) and the machine is immediately ready to receive the next carcase of any size.

The machine and the electrical circuit are made conforming to current CE regulating standards

- Electronic photocell barrier at front and rear
- Middle pressure beam electronic adjustable
- Lower pressure beam electronic adjustable
- Device for protruding top

technical details
max. workpiece height 1.200 mm
min. workpiece height 300 mm
max. workpiece length 2.500 mm
min workpiece length 300 mm
max. workpiece depth 700 mm
max. workpiece depth 100 mm
working height: 700 mm
feed speed 10 - 40 m/min
connected load 400 V / 50 cycles
installed power 6 kW

Including Motor driven conveyor belt
Belt width 700 mm
Length 2500 mm
Speed variable with inverter 10 - 40 m/min
Electrical circuit built into the clamp