MEP - VOLLAUTOMAT SHARK 332-1 NC 5.0 Ленточные пилы

cutting diameter: 300 mm
saw band length: 3320 x 27 x 0,9 mm mm
cutting width: 300 mm
Control: NC
capacity 90 degrees: flat: 330x 260 mm
capacity 90 degrees: square: 260 x 260 mm
capacity 45 degrees: square: 250 mm
capacity 45 degrees: flat: 270 x 200 mm
capacity 60 degrees: round: 180 mm
capacity 60 degrees: square: 170 mm
band speed: 15 - 100 m/min
total power requirement: 2,2 kW
weight of the machine ca.: 1,1 t
dimensions of the machine ca.: 3,3 x 2,83 x 2,23 m
Furnishing:
- fully automatic electro-hydraulic band saw with additional
semi-automatic, semi-automatic-dynamic and
manual operation
- Automatic cycle (cuts from 0° to 60° left)
- Semi-automatic, semi-automatic-dynamic and
manual cycle (cuts from 45° right to 60° left)
- Manual or semi-automatic dynamic cycle to make cuts outside
of series production can be carried out directly without programming.
- Numerically controlled band saw machines with the new, especially from MEP
Windows CE based controller developed for automatic machines.
- User interface with touch screen display of 7 and mechanical buttons for
the operating functions of the sawing machine.
- Stepless regulation of the cutting speed from 15 to 100 m/min
Frequency converter (inverter).
- Material feed with stepper motor via ball screw
- which is mounted on opposite ball bearings, Single stroke 600 mm
- repeatable to cut to any length.
- Automatic monitoring of cutting load
- through a servo valve mounted directly on the cylinder.
- The coolant pan is installed in the base frame
- Chip clearing brush.
- Bimetal saw band for solid and profile material.
- Tools and instructions for use with a list of spare parts
The data for this ad was created with ModulMWS - the software solution of LogoTech oHG.