WEHRMANN Combima DPF 가장자리 접착 기계

Single sided postforming edge processing machine
Brand: WEHRMANN  
Type: Combima DPF
New with 12 months warranty

Example with typical equipment; almost each equipment is possible. 
Please discuss your requirements with us 

Technical data:

Machine control:
BECKHOFF route control with 15? Touch-Screen for pre-selection of units and for saving programs. 

The workpiece transport via precision roller chain R75 with height adjustable top pressure. 

Feed speed: max. V=6-30 m/min. 
frequency controlled drive, 

Top pressure: Motorical height adjustment via axis adjustment in program

Right hand site equipped with 1 unit, width adjustment via NC axis:

1 Pre-milling unit
With 1 motor with vertical shaft,  400 V, 12,5 KW, 100 Hz, 6000 rpm.
Motor shaft Hydro D40
Swivable 90 - 180 degrees, move in/out for use

Left hand site Seite:
1 Infeed fence 

Infeed device,
For guiding the workpieces on the infeed fence for the lengthwise process, with 3 driven rollers.

1 Scoring motor from top
With motor 2,2 KW, 100 Hz, 6000 rpm.

1 Previous hogging unit 
With 1 motor laying, 400 V, 12,5 KW, 100 Hz, 6000 rpm.
Motor shaft Hydro D40
Swivable 90 - 180 degrees
Move in/out for use

1 Previous hogging unit
With 1 motor laying, 400 V, 12,5 kW, 100 Hz, 6000 rpm.
Motor shaft Hydro D40
Swivable 90 - 180 degrees
Move in/out for use

1 Flat routing- and radius miller
Wit motor 6,6 KW, 100 Hz, 6000 rpm.
Motor shaft Hydro D40
Swivable 90 - 180 degrees
Move in/out for use

1 Flat routing- and radius miller
With Motor 6,6 kW, 100 Hz, 6000 rpm.
Motor shaft Hydro D40
Swivable 90 - 180 degrees
Move in/out for use

1 Laminate milling unit
for high-precise overhang milling, with vertical shaft
Motor 1 kW, 200 Hz, 12000 rpm.

1 Radius gap milling unit
With 1 hanging motor 400 V, 1 KW, HSK 25
working in feed direction

1 Flat routing unit 
With horizontal shaft for milling the upper CPL area by set on the U-profile.

1 Radius milling unit
For milling a radius on the upper lengthwise edge at U-profiles 
mit Motor 4,4 kW, 100 Hz, 6000 rpm.

1 Laminate thicknessing unit 
for milling the CPLs in radius area on the lower lengthwise edge

1 Laminate thicknessing unit
for milling the CPLs in radius area on the upper lengthwise edge

1 Laminate monitoring

EVA glue application on the ?radius gap? 
With NORDSON - barrel melter

EVA glue application on the flat area of the CPL overhang
of the inner laminate site

Heating zone approx. 3000 mm long

Profile pressing tack with fix mounted sliding shoes and rollers

Cleaning via spraying nozzle from bottom

Milling unit 08.055 from top
With a motor 660 W, 400 V, 200 Hz

Buffing unit from top
With a motor 0,25 KW, FU-controlled, approx. 600-2000 rpm.

PU sealing of the inserting groove from top with Nordson barrel melting