DMG MORI HSC 70 linear 수직 콘솔 밀링 머신

· General

· Precision centre - Linear drive package - Active cooling for spindle, linear drives and electrical cabinet - Frame temperatur control - Direct measuring system - Chiptray, coolant/airblast changing - Full cabin including 2nd door; Control: 3D-Control Heidenhain TNC 640
·

· Technical Data

· Feed rate longitudinal/transverse/vertical
· 1-80000/1-80000/1-80000 mm/min

· Spindle taper
· HSK-A 63

· Rapid traverse longitudinal/transverse/vertical
· 80/80/80 m/min

· Working area 1

· Longitudinal
· 650 mm

· Cross
· 600 mm

· Vertical
· 450 mm

· Tool changer

· Type of magazine
· Chain

· Number of tools
· 30

· Type of gripper
· Double gripper

· Floor space/Weight

· Dimensions (L x W x H)
· 2,92 x 2,42 x 2,88 (3,0) m

· Weight approx.
· 9600 Kg

· HSC70 5-Axis Specification
· HSC70 with 5-Axis specification clamping area Ø 600 mm // Ø 23.61 inch swivel range B-axis +20/-110°; C-axis 360° table load max. 500 kg // 1102.31 lbs absolute measuring systems incl. permanent cooling of B- and C-axis motor

· Spindle speed up to 28,000rpm Shaft Cooling
· Spindle speed 20 up to 28,000 rpm within shaft cooling inclusive MPC Machine Protection Control (differently from standard)

·
· Drive power (100% DC) 20 kW

·
· Drive power (40% DC) 30 kW

·
· Speed range 20 - 28000 rpm

·
· Spindle taper HSK-A 63

· Tool Measuring Blum Laser
· Tool measuring Blum Laser Non-Contact optical tool measuring system including calibration tool

· Signal lamp 4-colour
· Signal lamp 4-colour Red: general error Yellow: intervention necessary Green: automatic mode Blue: set-up mode

· Production package 980l ICS coolant tempering
· Production package coolant tempered with internal coolant supply (ICS) Special coolant temperature control for more kinematic stability. Including paperband filter, coolant tempering and stirring device, swarf conveyor (scraper type) 40 bar/23 l/min/ 980

· Air blast through spindle centre dry
· Air blast through spindle centre (dry) activated by M function, (up 28.000rpm and higher)

· Oil and emulsion mist separator
· Oil and emulsion mist separator mechanical

· Application Tuning Cycle ATC
· Application Tuning Cycle ATC programmable feed parameter selection for machining task: accuracy/surface/speed

· Operation mode 4
· Operation mode 4 Process monitoring in the production Manual intervention with open doors of machining area. Release after check list has been filled in.

· Safety package for power failure
· Safety package for power failure Overload limiter, Undervoltage moni- toring with fast deceleration control

· Safety glass at operators door and side panel
· Laminated safety glass at operators door and side panel

· Package for tropical climate
· Package for tropical climate for ambient temperature up to max. 50°C: - temperature control of hydraulic oil - active drive chiller