workpiece diameter: 250 mm
centre distance: 0 mm
honing length
max.: mm
max. module: 5
Gear Ø, min./max. 10 /
250 mm
Module range 1 - 5
Length of teeth / max. table
stroke 500 mm
Height of centres of tailstocks 220 mm
Max.
weight of workpiece 50 / 100 kg
Honing head swivelling +/-
35 °
Speeds of honing tool 20 - 500 rpm
Size of honing
tool, Ø x width 300 x 40 mm
Workpiece speeds 500 -
3,000 rpm
Total adjustment of cross slide 270 mm
Rapid
traverse of cross slide 50 mm
Infeed travel of cross slide,
mechanical 1 - 8 mm/Ø
Roughing / finishing infeed 1 - 29 / 0.2 -
2.8 mm/sec
Table speeds, hydraulic 0 -
6 m/min
Total electrical load 5.5 kW - 380 V -
50 Hz
Weight 3,200 kg
Accessories / Special Features
Working parameters can be preset using counters and control
units. Automatic working process with workpiece counter.
All
roughing and finishing infeeds can be adjusted by a decade switch, as
well as by table reverse times and fast infeeds with preset times
(1sec = Ø 0.04 mm), set on a potentiometer. Ampere display,
etc.
Convex honing and conical honing are possible via templates.
Asymmetric honing is also possible if the workpiece is prepared
appropriately (i.e. pre-shaped).
Separate honing oil unit with
magnetic separator and fine filter.
Mechanical tailstocks for
manual loading. Oil mist separator.
Sliding doors with
foot switch. Separate hydraulic unit.
Condition :
Good. Machine can be inspected under power.
Delivery : Ex stock, as inspected.
Payment :
Net, after conclusion of contract.
We have a large selection
of gear machines available. Please let us know your
requirements.
The data for this ad was created
with ModulMWS - the software solution of LogoTech oHG.
ドイツ
Metzingen 
