: 1000 mm
: 1000 mm
: 1200x1000 mm
saw band length: 11300
x 80 x 1,3 mm
table height: 790 mm
band speed: 14 - 60
m/min
total power requirement: 18 kW
weight of the machine
ca.: 9,0 t
dimensions: 5,0 x 1,68 x 3,15 m
The semi-automatic,
hydraulic saws from the X-tech line offer the best
Saw technology
and best performance when cutting special steels
• The
electro-welded machine frame and the steel saw frame meet
requirements
all cutting needs and eliminate vibration and
noise.
• The chip conveyor is hydraulically driven and the speed
is
adjustable
• All movements of the machine (saw frame,
vice, feed,
Saw band guides) are carried out thanks to modern
linear guides with high
static and dynamic load performance,
which also has very low sliding friction
to guarantee.
•
Another characteristic feature is the roles for the
Positioning
of the material by a hydraulic motor
are driven. They move at
right angles to the material, and
thus allowing optimal
clamping of the material.
• Thanks to the height control of the
saw band position, the operator can place
the band in
place near the top edge of the material. After the cut is finished,
the tape
automatically raised back to the previous position.
Alternatively you can
also
Remain” can be selected in
the lower position. During the
The software compares the
cutting load with the cutting cycle
Default. This means that
the sawing system can be stopped in the event of
irregularities
become.
• The saw band is cleaned by
two adjustable steel brushes. The drive
takes place
hydraulically.
• The hydraulic unit including filter and
pressure gauge guarantees one
particularly quiet operation at
constant pressure.
• Finely ground carbide inserts that clamp
the saw blade, complete with
lateral, hardened and adjustable
guide rollers. The adjustable one
The tape guide automatically
moves as close as possible to the material.
• The saw band is
tensioned via a hydraulic cylinder, which is W51229549 carried out by
the
Machine software is controlled. The voltage is set
according to a given
Time automatically delimbed when the
machine is idle or after
a cycle has been carried out.
•
Automatic version with CNC control in the X-TECH 900 / 1200
models
a feed length of 500 mm for the series for high
production rates.
• The material is carried by a table with
seven rollers. These will
driven by a hydraulic orbital motor
through which the material
can be placed precisely even under
maximum load.
• All guided movements are carried out by four
recirculating ball guides with
one
high capacity for
static and dynamic loading, strong
reduced feed friction.
Tempered and ground prismatic
Guides.
Price on
request.
The data for this ad was created
with ModulMWS - the software solution of LogoTech oHG.
ドイツ
Deutschland 
