AUTOMATIC VERTICAL BINDING BALER, for FILM, WOVEN PP, PET, RIGID AND
SOFT PLASTICS, PAPER, CARDBOARD and more, 80 Tons ca. pressing force,
45 kw drive, complete with oil heating and cooling systems,
proportional pressure flow controller, Bale size LxWxH 1.100x720 mm
(adjustable length), feeding hopper size : 1.100 x 1.600 mm., Average
throughput rate, - with 30 kg/m3 materials 5-7 Ton/h, - with 50 kg/m3
materials 9-11 Ton/h, - with 120 kg/m3 materials 17-19 Ton/h, 5
vertical-wire binding, Cycle with no material, no twisting : 25 ca,
Pre-press flap with 2 x 20 Ton force, Exchangeable bottom plate in
hardox in channel and chamber, oil tank capacity 950 lt., Machine
weight ca.25.000 kg., General features, common to all balers:,
Construction ìn sturdy carbon steel with top EU components., Compact
and easy to use, Automatic binding, Fully automatic with adjustable
parameters on touch screen panel., A MODEM is installed for quick and
cheap remote assistance., PRE-PRESSING : to increase production per
cycle and bale size. No cutting knife to sharpen. Bales are heavier
and more compacted for better storing., HYDRAULIC UNIT : compact, on
the rear of the baler. A block contains all valves and pipes., AXIAL
DISPLACEMENT PISTON PUMP, mounted outside of the tank: low noise,
short adjustment time, service friendly, high speed, 100% torque
transfer., CARTRIDGES : the distribution block control the most
important movements: oil temperature remains lower, no pressure
surges., PRE PRESS FLAP and PRESS RAM can move simultaneously, so
saving time, INCREASED EFFICIENCY : little pressure loss + lower
energy consumption + higher capacity., G51237941 OPTIONAL OIL COOLING
SYSTEM : a thermostat will control oil temperature and automatically
activate the cooler., OIL TEMPERATURE and OIL LEVEL are controlled:
the baler will turn off if the thresholds are reached., WEAR and TEAR
on SEALS is reduced and possible prevented by the ball joint which
fastens the cylinders, A SIEMENS S7 1200 touch screen panel controls
the machine and all of its automatic functions (the machine can always
be used in manual mode), availability: ca 6 months from confirmation,
options available: perforator, intermidiate hopper, conveyor feed
hopper, exit table for bale, support 50 cm., wire coil stand,
capacity: 5-19 Tons/h depending on materials and feeding rate, type:
pre-press
Italie
ponderano 
