1 x Farrel Banbury internal Mixer,
Model 00C. Machine number: 91M7017, Year: 1992,
Stainless steel jacketed swing side (drop door design).
Maximum steam or water pressure 150psi,
chrome plated two wing cored rotors with spherical roller bearings, gross capacity of mixing chamber 4.24 liters.
5" Diameter ram cylinder,
maximum pressure 100psi.
Chrome plated single slope V-bottom, stainless steel, pneumatically operated front door,
F.Y.A. dust stops, oil seals, oil injector, thermocouple.
With 65kw (87hp), 340/440 volt, 1500 rpm motor, reducer ratio 15:1. Unit mounted in an enclosed cabinet with a pull-out discharge drawer. Includes an operator panel.
In good condition.
1 x Farrel model F80 banbury internal mixer,
Serial number: 996006,
Year of manufacture: 1999 (new),
Chamber volume 80litre,
With 4 wing ST rotors,
hydraulic drop door dicharge with Linear actuator and spade latch,
FYH hydraulic dust stops,
With 600 HP DC variable speed motor and drive/SCR controller,
Complete with hydraulic unit, Lubrication system, 3 Zone TCU and Farrel series 2000 operator panel.
High spec mixer (fully hard chrome plated chamber and rotors).
Previously used for PVC.
1 x Farrel model F270 Banbury internal mixer,
Machine number: 98M5007, Year July 1998,
270 litre capacity,
2 wing rotor design,
FYH type dust seals,
Hydraulic drop door with linear actuator,
Process oil system,
with David Brown unidrive gearbox, serial no GS50277,
Leroy Somer Type LSM54 L76P 1492kW AC motor, Dec 2001, RPM 1000/1200, 750V (includes 11kv > 750v transformer).
Output rpm 49.8/43.
Alstom \Syncdrive\ AC variable speed drive controller, 1940 KVA, 750V, digital drive new in 2001.
With Siemens S5 Control system.
In feed conveyor and dust extraction system also for sale if required.
Spare refurbished Leroy Somer motor also available.
Complete and in good condition (still installed at a factory in UK).
FARREL CNC DUAL RAM VERTICAL TURNING LATHE - C AXIS (5.1M SWING)
Year of manufacture: 1996-2004 Retrofit,
Control: FANUC 15TT,
Modernization to CNC in year 2004,
X ball screw replacement in year 2010 (left and right heads),
Oiling system renovation in year 2010,
Fix cross rail machine (can be lifted to upper and lower position),
C axis (table positioning),
Table diameter: 4800mm,
Largest swing around: 5100mm (17Â´),
Largest work piece height: 1828mm (72"),
Hydrostatic ways on table bed,
Table load: 125 ton maximum (uniform weight distribution),
Table is 1 part,
Table RPM: 0,5 - 35,
Electricity: 400 V, 50Hz (transformer changes to 460V and 60 Hz - transformer is part of the machine)